Inventor Hole Property Panel-clearance dimension values don't update until face is selected

March 29, 2023 Joanna Gryszka

Issue:

In Inventor 2021 through 2023 when adding a clearance Hole feature, if a face or point(s) is not selected, the thread values don't update if you change the size to get a preview of the dimensions.

Changing the Size in the pull down-menu doesn't update the dimension preview in the 'Behavior' section of the Hole Property Panel:

In previous versions these values would update with no position geometry (face,  plane or sketch/work points) selected.

Causes:

This is a confirmed issue logged with Incident ID:66875 in this Autodesk article:
If a point or face is NOT selected in the hole command for a clearance + counter bore hole, the diameter in the behavior section does not change when the hole diameter changes for Inventor

Solution:

To be able to see clearance dimension values update as you choose a different size, select a face or plane in the Hole Property Panel:

Note: Tapped and Taper Tapped hole dimension values update without the need to pre-select a face or plane.

About the Author

Joanna Gryszka

Manufacturing Technical Support Specialist<br><br>Joanna has over eight years of experience working with Autodesk products. She started supporting core AutoCAD and network installations of all Autodesk products. She now has five years of experience with Inventor. <br> She graduated from Mechanical Engineering and has been providing solutions to clients and dedicating her knowledge to the Solution Center since then.

More Content by Joanna Gryszka
Previous Article
Autodesk Inventor Apprentice failed to load on Get-Checkout from Vault
Autodesk Inventor Apprentice failed to load on Get-Checkout from Vault

When performing a “Get/Checkout” from within the Vault Thick Client you receive a message stating “Unable t...

Next Article
Autodesk Access ‘An error occurred. Please try again'
Autodesk Access ‘An error occurred. Please try again'

Need tech support? Let us help!

Learn More