Issue:
You are using AutoCAD Dimensions and you use a Radial or Diameter Dimension. When you do, you get an “R” or “Ø” in front of your Dimension value and you would like to remove these.
Causes:
These are set as defaults.
Solution:
You must place a blank space in the Prefix section of Primary Units Tab in the Dimension style.
- Launch the Dimension Style Dialog (DIMSTYLE)
- Modify the current Style or the one you do not want this value assigned.
- Select the Primary Tab.
- In the Prefix area place a blank space.
- Except the changes and test your Dimension
Note:
-This could also be in a Dimension override if this does not work check the override style.
- To add these to the end place R or %%C (this is the code for Ø) in the suffix area in Dimstyle.
About the Author
Follow on Linkedin More Content by Jeff Arbogast
